BIXOLON SLP-TX220 Labels & Ribbons

The BIXOLON SLP-TX220 does both. In thermal transfer mode it prints through a ribbon for durable, long-life labels; in direct thermal mode it prints straight onto heat-sensitive stock with no ribbon at all, which is how most shipping labels are produced.

The BIXOLON SLP-TX220 takes thermal transfer ribbons up to 4.33" wide, up to 984 ft (300 m) long, on a 1" core, wound coated side out (CSO). Wax suits coated paper labels, wax-resin handles synthetics and heavier handling, and full resin is the choice for chemical, solvent and outdoor exposure.

The BIXOLON SLP-TX220 accepts media up to 2.36" wide, with a maximum print width of 2.13". Any narrower label will run as well, so long as the roll core and outside diameter also fit the media bay — width alone is not enough.

The BIXOLON SLP-TX220 takes rolls on 0.5" / 1" / 1.5" cores, with a maximum roll diameter of 5.12". A roll on a larger core will not seat on the spindle, and one over the diameter limit will not let the cover close.

No. The BIXOLON SLP-TX220 takes 0.5" / 1" / 1.5" cores. A 3" core roll — the usual industrial format — will not fit its spindle, so check the core before ordering, not just the label size.

Three things stop a roll loading in this printer: the roll is over 5.12" in diameter; the core is not 0.5" / 1" / 1.5". Label width is usually the first thing people check and the least likely culprit — core size is the common one.

Yes. Because the BIXOLON SLP-TX220 prints thermal transfer, it can image polypropylene, polyester and other synthetic facestocks that direct thermal printers cannot mark. Pair them with a wax-resin or full resin ribbon; wax will not anchor properly to a synthetic surface.

Vantage Labels stocks blank thermal labels and printer ribbons that fit the BIXOLON SLP-TX220, shipped from Canadian stock. Everything listed on this page has been checked against the printer's published media specifications — width, core, roll diameter and ribbon format — rather than matched on the printer's name.